With the cover seated in the floor, pull upward on loops and twist them one-quarter turn so that they are no longer parallel to the slots in the cover. The correct wheel nut tightness is 95 ft lb 130 N·m. It can start anytime the ignition switch is on. Before the pointer reaches the red area, ease up This light will illuminate when selecting on the accelerator to prevent engine damage. If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic.
The number dialed may Towing Assistance not be applicable with the available mobile service and If you need towing assistance: area. This feature is activated whenever you turn on the rear window defroster. Leaving inside and outside mirrors, and fasten your seat belts. You or damage your vehicle. Turn the end of the lever to The multifunction lever on the left side of the steering the second detent for headlight operation. The function of the left-hand control is different depending on which mode you are in. The vehicle should be jacked on a firm level surface only.
Park the vehicle on a firm level surface as far from the edge of the roadway as possible. Park the vehicle on a firm level surface as far from the edge of the roadway as possible. They contain carbon cause serious injury or death. Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result. . Brake seal components could has been in a tightly closed container. To lower the head restraint, press the adjust- forward and backward.
Adjust the mirror to center on the view through the rear window. Be sure the hood is fully latched before driving your vehicle. This feature can be turned on or turned off. A long break-in period is not required for the engine and drivetrain transmission and axle in your vehicle. Activation will now occur for the programmed device i. Pull far enough off the road to avoid the danger of being hit when operating the jack or changing the wheel. Get access to our 2012 Jeep Liberty repair information right now, online.
The Homelink indicator will flash slowly To reprogram a channel that has been previously trained, and then rapidly after Homelink has received the fre- follow these steps: quency signal from the hand-held transmitter. This noise should be considered normal, and it checked if a leak is suspected, abnormal noises are does not in any way damage the steering system. Always wash your ve- resistance built into your vehicle. To be used for wide range of conditions, while maximizing driver con- flat towing behind another vehicle. The system will shut the engine off in two Should this occur, have the vehicle serviced as soon as seconds if someone uses an invalid key to try to start the possible by an authorized dealer. Do not store the cargo cover on the cargo floor or in the passenger compart- ment. If vehicle speed is detected, a chime will sound the parking brake.
Pull down then rearward towards the rear of the vehicle then down to engage the locking mechanism. Using the point of a ballpoint pen or similar object, 7. If the light remains on after the All of the keys provided with your new vehicle have bulb check, it indicates that there is a problem with the been programmed to the vehicle electronics. In a sudden stop or a collision, a tie-down could pull loose and allow the child seat to come loose. The feature is active whenever the ignition is on.
To access, lift up on the cover. These labels can peel label facing up. Keep this in mind when checking tire pressure inside a garage, especially in After inspecting or adjusting the tire pressure, al- the winter. Do not attempt to raise the vehicle by jacking on locations other than those indicated in the Jacking Instructions for this vehicle. This may result in a slightly different feeling or response during normal operation in the upper gears. If the system fault 1. Electronic Volume Control The electronic volume control turns continuously 360 degrees in either direction without stopping.
Press this button to change the display to time of day. Using a screwdriver, reach into the opening and press 7. In case lock the doors with the manual door lock plungers or the driver's door lock cylinder. Inspect the belt system periodically, checking for cuts, frays, or loose parts. Press and hold the brake pedal.
Minimum tire lift provides maximum stability. Turn the steering wheel all the way to the right to 1. Continue to hold both buttons and observe the indi- Reprogramming A Single HomeLink Button cator light. The load floor has a to secure loads safely when the built-in storage bin that can hold vehicle is moving. In 48, 64, 96, 128, 44.
The windshield, is free of obstructions such as leaves. Acceptable methods are to tow the vehicle on a flatbed or with one end of vehicle raised and Internal damage to the transmission or transfer the opposite end on a towing dolly. Jeep is a registered ®. If the medium on the disc. Raise the vehicle only until the tire just clears the surface and enough clearance is obtained to install the spare tire.